X hits on this document

120 views

0 shares

0 downloads

0 comments

46 / 50

Battery Connections

CAUTION: To help prevent electrical shorts or electrical fires, all electrical connections must be clean and tightly secured.

4. At the unit, locate the large black battery cable marked NEG -. Route this cable to the battery, cut to the proper length and add battery lug from installation kit. Connect to the NEGATIVE terminal of battery (Detail C).

CAUTION: To prevent the unit from starting unexpectedly, set all electrical controls to the OFF position.

Although the unit comes pre-wired from the factory, wire connections at the battery are required (Detail A). Unroll the harness bundle from the unit.

Route and secure all harnesses and battery cables with provided clamps.

CAUTION: All battery connections and electrical wires must be properly routed and secured to prevent rubbing, chafing or making contact with sharp, moving or hot components. Do not route battery cables together with fuel lines.

NEGATIVE CABLE

POSITIVE CABLE

1. At the unit, locate the large black cable marked POS+. Route this cable to the battery, cut to the proper length and add battery cable lug from installation kit. Connect to POSITIVE terminal of battery (Detail B).

UNIT CONTROL WIRE

2. At the unit, locate the #2 wire. Route this wire to the battery, cut to the proper length and add fuse holder assembly. Use battery cable crimper to securely crimp #2 wire and the fuse holder together and heat shrink the connection. Apply a liberal amount of Superlube to the 60 amp fuse and fuse holder and then install fuse. Connect #2 wire to the POSITIVE terminal of battery (DETAIL B).

FUEL PUMP HARNESS

3. Locate and route the Fuel Pump harness to the fuel pump and connect to matching connector at the pump.

46

Document info
Document views120
Page views120
Page last viewedTue Dec 06 16:52:25 UTC 2016
Pages50
Paragraphs453
Words4996

Comments