X hits on this document

PDF document

REGULATION FOR THE MANDATORY REPORTING OF GREENHOUSE GAS EMISSIONS - page 35 / 137

324 views

0 shares

0 downloads

0 comments

35 / 137

    • (C)

      Average high heat value (HHV) by fuel type if measured or provided by fuel supplier, reporting in units of MMBtu per fuel unit as specified in section 95110(a)(3)(A);

    • (D)

      CO2 emissions by fuel type (metric tonnes), separately for kiln and non-kiln units, including separately calculated and identified CO2 emissions from biomass-derived fuels (metric tonnes);

    • (E)

      CH4 emissions by fuel type (metric tonnes); and,

    • (F)

      N2O emissions by fuel type (metric tonnes).

  • (4)

    Fugitive emissions, including:

    • (A)

      Coal consumption by coal type (short tons),

    • (B)

      Emission factor (million standard cubic feet (scf) CH4/metric tonne), and

    • (C)

      CH4 emissions from coal storage (metric tonnes).

  • (5)

    Indirect energy usage, including:

    • (A)

      Electricity purchases from each electricity provider (kWh), and

    • (B)

      Steam, heat, and cooling purchases from each energy provider (Btu).

  • (6)

    Efficiency metrics, using both of the following calculation methods:

    • (A)

      CO2 emissions per metric tonne of cementitious product, including:

      • 1.

        Amount of own clinker consumed (metric tonnes),

      • 2.

        Amount of clinker added to stock (metric tonnes),

      • 3.

        Amount of clinker sold directly (metric tonnes),

      • 4.

        Amount and type of clinker substitutes consumed for blending (metric tonnes), and

      • 5.

        Amount and type of cement substitutes consumed for blending (metric tonnes).

    • (B)

      CO2 emissions per metric tonne of clinker, including:

      • 1.

        Amount of own clinker consumed (metric tonnes),

      • 2.

        Amount of clinker added to stock (metric tonnes), and

      • 3.

        Amount of clinker sold directly (metric tonnes).

  • (b)

    Calculation of CO2, N2O, and CH4 Emissions. Operators of cement plants shall calculate emissions and indirect energy usage for each source as specified in this section.

    • (1)

      Total CO2 Emissions. Operators of cement plants shall calculate total CO2

emissions using either (A) or (B) below.

  • (A)

    Continuous emissions monitoring systems (CEMS) as specified in section 95125(g). Operators of cement plants that measure CO2 emissions using CEMS shall also report fuel usage by fuel type.

  • (B)

    Process CO2 emissions from cement manufacturing as specified in section 95110(c) and stationary combustion CO2 emissions as specified in section 95110(d).

35

Document info
Document views324
Page views324
Page last viewedSun Dec 04 19:36:26 UTC 2016
Pages137
Paragraphs3283
Words41863

Comments