X hits on this document

83 views

0 shares

0 downloads

0 comments

6 / 25

UNLOADED,

AND

THE

BOLT OR

BREECH IS

OPEN! INSTALL LOADED

NEVER ATTEMPT TO REMOVE A SHOTGUN CHOKING DEVICE FIREARM!

OR ON

A

UNLOAD TUBE REMOVAL- 1 YOUR

A-5

FULLY.

INSPECT

CHAMBER,

FEED

MECHANISM

ZINE TAIN

TO MAKE SURE ANY SHELLS.

THEY

DO

AND NOT

THE MAGA- CON-

2 Open the action, locking it rearward, and place the “safety” in the “on safe” position.

3 Use the Invector wrench to loosen the tube, turning it counterclockwise. Finger twist the tube the rest of the way out of the barrel.

TUBE INSTALLATION- 1 UNLOAD CHAMBER, ZINE TO SHELLS. YOUR A-5 FULLY. INSPECT THE FEED MECHANISM AND MAGA- MAKE THEY DO NOT CONTAIN ANY

2 Open the action and place the “safety” in the “on safe” position.

3 Before installing a tube, check the internal choke tube threads in the muzzle, as well as the threads on the Invector choke tube to be

sure they are clean. Lightly oil the threads with an oil like Browning Oil.

4 Using your fingers, screw the appropriate tube into the muzzle end of the barrel, ta- pered end first, notched end outward. When it becomes finger-tight, use the invector choke tube wrench to firmly seat the tube.

THE INVECTOR CHOKE TUBE SHOULD BE PERIODICALLY CHECKED TO ASSURE THAT IT IS TIGHT AND FIRMLY SEATED. BEFORE CHECKING, FOLLOW THE SAFETY GUIDE- LINES OUTLINED ABOVE.

Replacement and additional tubes and wrenches are available from your Browning dealer, or by writing to:

Browning Consumer Department, One Browning Place, Morgan, Utah 84050. 801-876-2711.

Canadian customers please call or write to:

Browning Canada Sports Ltd./Ltee, 5617 Chemin St-Francois, St-Lament., Quebec, Canada H4S 1W6. (514) 333-7261.

INVECTOR CHOKE TUBE CODE—

To identify individual Invector tubes, refer to the abbreviated indications on the side of the

tube, or use the identification mark(s) located on the top rim of each tube. (See Figure 14).

INVECTOR TUBE SELECTION

To help you choose the correct choke tube for each hunting situation, all Browning Invector choke tubes are inscribed on the side with the patterns they produce with both lead and steel shot. Each Invector tube also has notches in the top rim of the tube. These notches are a code to allow you to determine the choke designation while the tube is installed. Rim notches refer spe- cifically to lead shot. you will need to use the chart below to cross-reference from lead to steel, and determine the appropriate tubes for your am- munition and hunting/shooting situation.

Several tubes are supplied with your Browning shotgun. The tubes listed are also available as ac- cessories. Remember, Standard Invector and Invector-Plus tubes are not interchangeable. Invector-Plus tubes are for Browning guns with back-bored barrels, such as your new Auto-5. Older Auto-5 shotguns are Standard Invector. Be- fore removing/installing tubes, or reading the rim

Document info
Document views83
Page views84
Page last viewedThu Dec 08 02:52:23 UTC 2016
Pages25
Paragraphs1194
Words10274

Comments