X hits on this document

273 views

0 shares

0 downloads

0 comments

10 / 76

STEP 2: Install the rechargeable battery pack into the handset

note

The handset is powered by a rechargeable battery pack. The battery recharges automatically when the handset is placed in the cradle.

Use only the Uniden (BT-446) rechargeable battery pack supplied with your cordless telephone.

Replacement battery packs are also available through the Uniden Parts Department (see back cover page).

  • 1)

    Press down on the handset battery case cover (use the finger indention for a better grip) and slide the cover downward to remove.

  • 2)

    Plug the battery pack connector (red & black wires) into the jack inside the battery compartment. (The connector notches fit into the grooves of the jack only one way.) Match the wire colors to the polarity label in the battery compartment, connect the battery and listen for a click to insure connection.

  • 3)

    Make sure you have a good connection by slightly pulling on the battery wires. If the connection is secure, the battery jack will remain in place.

  • 4)

    Place the battery case cover back on the handset and slide it upwards until it clicks into place.

[9] SETTING UP YOUR BROADBAND PHONE

www.uniden.com

SETTING UP YOUR BROADBAND PHONE

Document info
Document views273
Page views273
Page last viewedMon Jan 23 23:41:19 UTC 2017
Pages76
Paragraphs1684
Words16594

Comments