X hits on this document

25 views

0 shares

0 downloads

0 comments

3 / 8

Dialogic® D/41JCT-LS Media Board

Datasheet JCT Media Boards

Environmental Requirements — PCI and PCI Express

Operating temperature Storage temperature Humidity

+32°F (0°C) to +122°F (+50°C)

  • 4°F (–20°C) to +158°F (+70°C)

8% to 80% noncondensing

Telephone Interface

Trunk type Impedance Ring detection Loop current range Echo return loss Crosstalk coupling Receive signal/noise ratio Frequency response Connector

Loop start 600 Ohms nominal 15 Vrms minimum, 13 Hz to 68 Hz, (each configurable by parameter**) 20 mA to 120 mA Configurable by software parameter Less than –70 dB at 1 kHz channel to channel 70 dB referenced to –15 dBm 200 Hz to 3400 Hz ±3 dB (transmit and receive) 4 RJ-11 type

Approvals and Compliance Hazardous substances

RoHS Compliance Information at A Guide to RoHS Compliance at Dialogic

Safety

Canada United States Europe International

CSA 60950-1 UL 60950-1 EN 60950-1 IEC 60950-1

EMC

Canada United States Europe Japan

ICES-003 Class A FCC Part 15 Class A EN55022/EN55024, CISPR22/CISPR24 and ETSI EN 300386 VCCI Class A

Telecom Approvals

Canada European Union Japan United States Country-specific approvals

CS-03 TBR 21 JATE Blue Book FCC Part 68

See the Product Declarations & Global Approvals list at http://www.dialogic.com/declarations/ or contact your Authorized Distributor

Reliability/Warranty Estimated MTBF

Per Telcordia Method 1 PCI: 274,000 hours PCI Express: 230,000 hours

Warranty

Warranty Information at http://www.dialogic.com/warranties

  • Average speech mandates +16 dB peaks above average and preserves –13 dB valleys below average.

** Analog levels: 0 dBm0 corresponds to a level of +3 dBm at tip-ring analog point. Values vary depending on country requirements; contact your account manager.

3

Document info
Document views25
Page views25
Page last viewedThu Dec 08 02:09:18 UTC 2016
Pages8
Paragraphs219
Words2364

Comments