X hits on this document

PDF document

This document provides domestic and international regulatory compliance and safety information for ... - page 3 / 78

244 views

0 shares

0 downloads

0 comments

3 / 78

Agency Compliance

Table 1

Agency Compliance

Type

Compliance

EMI/EMC

Emissions:

47CFR15 Class A (FCC); CISPR22 Class A; EN55022 Class A; AS/NZS 3548 Class A (ACA); ICES003 Class A (Industry Canada); V-3 Class A (VCCI); CNS13438 Class A (BSMI); EN61000-3-2; EN61000-3-3; EN300386 Class A

Immunity:

EN50024, EN50082-1, & EN61000-6-1 (including EN 61000 4-2 Electrostatic Discharge; EN 61000 4-3 Radiated Susceptibility; EN 61000 4-4 Electrical Fast Transients; EN 61000 4-5 Power & Signal Line Surges; EN 61000 4-6 Injected RF Swept Immunity; EN61000-4-11 Voltage Dips + Sags); EN300386

Post Telephone & Telegraph (PTT)

This equipment complies with all the regulatory requirements for connection to the communications networks of each country in which it is sold.

USA

FCC Part 15 Notice

Cisco 2600, 3600, and 3700 series routers comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  • 1.

    This device may not cause harmful interference.

  • 2.

    This device must accept any interference received, including interference that may cause undesired

operation.

Modifying this equipment without Cisco’s authorization may result in the equipment no longer complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Compliance with FCC Part 68 Requirements

This equipment complies with Part 68 of the FCC rules. On the bottom of the chassis is a label that contains, among other information, the FCC registration number and ringer equivalence number (REN) for this equipment. If requested, this information must be provided to the telephone company.

Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Regulatory Compliance and Safety Information

OL-10259-02

3

Document info
Document views244
Page views244
Page last viewedFri Dec 09 02:33:57 UTC 2016
Pages78
Paragraphs2241
Words22093

Comments