X hits on this document

PDF document

This document provides domestic and international regulatory compliance and safety information for ... - page 4 / 78

248 views

0 shares

0 downloads

0 comments

4 / 78

Agency Compliance

If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. If advance notice is not practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the operation of this equipment. If this happens, the telephone company will provide advance notice in order for you to make the necessary modifications to maintain uninterrupted service.

Normally, this equipment will be used in conjunction with FCC registered equipment that limits the Encoded Analog Content that provides the required Billing Protection. If the connected equipment is not of this type, an affidavit must be supplied to the telephone company where the network connection is to be made. The affidavit is to be notarized, and is to be filed at least ten days before the initial connection.

The facility interface and service order codes are shown in Table 2.

Cisco 2600 series, 3600 series, and 3700 series routers bearing labeling identification number 5B1USA-27857-MF-E comply with the following requirements:

Service Order

Code (SOC)

Jack Type (USOC)

RJ-11C

RJ-11C

6.0N

RJ-49C via NT1

6.0N

RJ-49C

6.0N

RJ-48C

FCC Rules and Regulations 47 CFR Part 68

TIA/EIA/IS-968, Technical Criteria for Terminal Equipment to Prevent Harms to the Telephone Network, July 2001, as adopted by the Administrative Council on Terminal Attachments (ACTA)

See Figure 1 on page 6 for Cisco's Supplier Declaration of Conformity. This document is also available online at http://www.cisco.com/warp/customer/508/dofc/163898.pdf.

Interface Type

Facility Interface Code (FIC)

ADSL1

Metallic

SHDSL

Metallic

BRI-S/T

02IS5

BRI-U

02IS5

T1 data

04DU9-BN

04DU9-DN

04DU9-1KN

04DU9-1SN,

Table 2

Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers Facility Interface and Service Order Codes

T1 voice

04DU9-BN 04DU9-DN 04DU9-1KN 04DU9-1SN, 04DU9-1ZN

FXO1

02LS2 02GS2

CAMA1 DID (Reverse battery) E&M tie trunk

02RV2-0 02RV2-T

TL11E TL12E TL31E TL32E

6.0Y

RJ-48C

RJ-11C RJ-21X

AS.2 9.0F

RJ-11C RJ-11C

RJ-2EX RJ-2FX RJ-2GX RJ-2HX

Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Regulatory Compliance and Safety Information

4

OL-10259-02

Document info
Document views248
Page views248
Page last viewedFri Dec 09 19:49:15 UTC 2016
Pages78
Paragraphs2241
Words22093

Comments