X hits on this document

20 views

0 shares

1 downloads

0 comments

3 / 4

1.4

Select the proper location. It will be necessary to fabricate or purchase a mounting bracket to suit your particular installation. See Figure 2 for recommended mounting bracket dimensions. The Airfin Cooler should be located 6-12” above and no more than 4’ from the seal chamber.

Mounting Bracket Details

Figure 2

10.50"

9.00" Min.

5.25"

9.00" Min.

    • 5.25

      "

    • 10.50

      "

4 - .437” Dia. holes as shown

1.5

Carefully place the Airfin Cooler on the mounting bracket. The Airfin Cooler should be positioned so that the least amount of elbows or tube bends are needed for the inlet and outlet piping.

Note: If the inlet and outlet fittings are not in the desired positions, the coil assembly can be rotated 360to any desired position. Loosen the four hex head bolts (Part No. 10 of Model 625 FC and Part No. 5 of Model 625 NC) and rotate the cooling coil/shroud assembly to the desired position. Be sure to tighten the four hex head bolts securely.

    • 1.6

      After the unit has been placed on the mounting bracket in the desired position, secure it down with four hex nuts (3/8” - 16 UNC-2B) with lock washers.

    • 1.7

      Consult your assembly drawing for the connections size and location. The hot product line to the Airfin Cooler should be piped to the top of the unit and the cooled product outlet line should be piped from the bottom of the unit. Connect the inlet and outlet lines with suitable piping or tubing.

    • 1.8

      Be sure to install a vent value in the hot product inlet line. The vent valve should be located at he highest point in the piping.

    • 1.9

      The Model 625 FC Airfin Cooler has a 1/3 HP motor. Consult the assembly drawing for your motor specifications.

3

Document info
Document views20
Page views23
Page last viewedFri Oct 28 05:24:32 UTC 2016
Pages4
Paragraphs105
Words910

Comments