X hits on this document

56 views

0 shares

0 downloads

0 comments

22 / 30

2009 Wildwood Water Utility Specifications

Updated 06/29/09

The Integral Hydrant Storz nozzle is installed on new hydrants during assembly.

The HIHS meets or exceeds the requirements of AWWA C502 regarding material and pressure testing. A Storz spanner wrench is required for cap removal.

The Storz nozzle shall have a brass metal face seal and hard anodized aluminum Storz ramps and lugs. The aluminum’s finish shall be hardcoat anodized to Mil-A-8625f, Type 3, and dark gray. The adapter shall be made of forged or extruded 6061-T6 aluminum.

The blind cap shall have hard anodized aluminum Storz ramps and lugs; made of forged or extruded 606J-T6 aluminum. The center cap shall be equipped with a suction seal. The cap shall be connected to the adapter or the hydrant with a

O.125” vinyl coated aircraft cable. The high torque cap requires a Storz spanner wrench for removal. Once installed, the Integral Hydrant Storz with cap extends less than 2" front the hydrant nozzle.

Figure 9

22

Document info
Document views56
Page views56
Page last viewedSun Dec 04 02:47:42 UTC 2016
Pages30
Paragraphs411
Words6198

Comments