X hits on this document

262 views

0 shares

0 downloads

0 comments

71 / 97

underside of floor during wheel jounce conditions. (On Type D, transit style buses the Flat Floor begins after front wheel wells. Not available if engine is in the rear of the bus.)

38.

Headroom requirements shall remain the same as a standard vehicle and shall accommodate either a low headroom vehicle or an optional high-headroom vehicle. Flooring with Recessed Track

39.

Flooring with four recessed tracks parallel to the aisle of the bus. State number of wheelchair positions and/or track-mounted passenger seating required ________. The school district must maintain the seat spacing according to FMVSS 222. Floor Covering – Color Specify color:

_____________ Bonded Floor covering ______

One piece floor covering____

___

40.

Contact vendors for available colors Floor Covering – White line (No Standing)

OPTION NO.

DESCRIPTION

41.

White line as part of floor covering material, which extends across aisle at entrance to passenger seating. Floor Insulation Plywood

The physical thickness shall be no less than five-eighths inch (5/8"). (one-half

inch (1/2") for Type A) 41. A. ______ BC Grade exterior type

41. B.

Pressure Treated

41. C.

Marine Grade

42.

_______ _______ Note: Marine Grade plywood should extend life of floor where moisture is a problem. Headroom Maximum,

43.

Increased height of bus ceiling for maximum headroom for stated size of bus. (Bidder to specify in inches). Heater, Rear, auxiliary under seat mounted with heater water circulating pump

It shall be mounted near the rear of the bus and in such a manner so as not to interfere with the securing of seats to the floor. The Btu/hr. rating shall be in accordance with SBMTC Standard No. 001. Heated conduits inside the buses shall be insulated or shielded to prevent injury to the driver or passengers. The heater shall have a minimum output rating (re-circulating air rating - not fresh air intake rating) as follows: (24 - 42 -passenger) buses: 40,000 Btu/hr. 14 to 35 passenger buses do not require a water circulating pump. (47-passenger and larger) buses: 75,000 Btu/hr.

Section F-8

Document info
Document views262
Page views262
Page last viewedFri Dec 09 09:49:05 UTC 2016
Pages97
Paragraphs2216
Words30825

Comments