X hits on this document

371 views

0 shares

0 downloads

0 comments

81 / 97

____

LIGHTS, Backup: 2 four inch required (to meet FMVSS No. 108)

____

LIGHTS, Tail and Stop: 1. Must be LED 1. 2 required FMVSS 108 2. Metal or durable plastic base 3. Snap – on lens not acceptable 4. Stop lamps to be 38 square inches minimum, and mounted near belt line 5. A set of 4” minimum tail/stop lamps shall be installed below the 38 square inch set

____

LIGHTS, Clearance and Identification: 1. Must be LED 2. 3 red on top close to vertical centerline 3. Lamp centers spaced not less than 6 or more than 12 inches apart 4. Activated by headlight switch 5. Sealed type light 6. Surface mounted with rust proof material guard unless recessed 7. Use a universal type sealed electrical plug connector

____

LIGHTS, Alternately Flashing Signal: 1. Must be LED 2. 2 red, 2 amber (towards center) 3. Amber manual, red automatic when door opens or stop signal arm is extended 4. Lights shall be wired independently of ignition switch 5. If master switch is on the W/C lift door shall activate the warning lights when open

____

TURN SIGNAL/Hazard Warning Lamp: 1. Must be LED 2. Meeting FMVSS 108 3. Be amber

C-10

C-9

D-4

C-10

C-9

____

TURN SIGNAL /Hazard Warning Lights: 1. Front – manufactured standard meeting FMVSS 108 2. Side – buses of 36 PAX or larger equipped with amber side mounted lights 3. Left side mounted rearward of the top of the stop signal arm 4. Right side mounted rearward of the service door

____

LIGHTS, Exterior Door Fixture 1. Illuminates ground around service door 2. Activates with step well light 3. Mounted outside below the beltline by the service door 4. Light must be installed to prevent a burn hazard

(3) REAR LIGHTS AND SIGNALS

C-10

C-10

C-9

(4) OTHER

____

BUMPER, Front:

B-4

1. Pressed steel channel or equivalent material (except Type A 19,500 GVWR or less may have OEM supplied bumper

  • 2.

    At least 3/16" thick and not less than 9 1/2 inches wide (high)

  • 3.

    Black (Type A mfg standard color)

  • 4.

    Means provided to mount license plate for unobstructed view

____

MIRROR SYSTEM: (All buses):

C-11

Section G-4

Document info
Document views371
Page views371
Page last viewedTue Jan 24 05:44:04 UTC 2017
Pages97
Paragraphs2216
Words30825

Comments