X hits on this document

234 views

0 shares

0 downloads

0 comments

83 / 97

2. Lettering adjacent to fuel filler opening indicating fuel type

____

LIGHTS, Intermediate Identification:

  • 1.

    Must be LED

  • 2.

    Not required on buses less than 30 feet long

  • 3.

    Sealed type light.

  • 4.

    Surface mounted with rust proof material guard unless recessed

  • 5.

    Use a universal type sealed electrical plug connector

C-10

SCHOOL BUS LETTERING:

C-8

____

  • 1.

    “School Bus” on both sides, front and rear roof caps

  • 2.

    8” high, 6” on Type A buses, 1” wide stroke, black block letters. Decals on APL are acceptable

  • 3.

    "School Bus" front & rear in black lettering with yellow reflective background if not lighted design

  • 4.

    "School Bus" on both sides located between bottom two rub rails, the same height and near the center of the school bus

  • 5.

    "School Bus" both sides in black with reflective background or reflective lettering

____

SCHOOL NAME LETTERING: 1. School name lettering on both sides 2. Lettering shall be between the upper two (2) rub rails near the belt line 3. Five (5) or six (6) inch lettering 5/8 inch block stroke lettering 4. Paint or decals (black in color) * School district or contractor logo may also be added as near to the front of both sides of the bus as possible. The logo may not be larger than 500 square inches. C-8

____

RUB RAILS, Black:

C-13

Four (4) required: one at window level, one at seat level, one at floor level and one at skirt level The rails shall be one-piece continuous construction, 4” or more in width, made of 16-gauge steel and constructed in corrugated or ribbed fashion 1. Seat level from the entrance doorpost around body (except emergency door) to point of curvature near cowl on left side

  • 2.

    Window level at the bottom edge of the windows

  • 3.

    Floor line & bottom of outer skirt shall cover same longitudinal area as seat level rail except at

wheel housings and shall extend only to radii of right and left corners

  • 4.

    All rub rail ends must be closed

  • 5.

    All rub rails must be bolted or riveted at top and bottom to each side post and to exterior panels

between posts 6. All rub rails must have drainage: bottom edge of each rail shall have provisions for drainage of

accumulated moisture

REFLECTORS: 3 each side lower part of body: rear (red), * middle (amber) and front (amber)

____

  • *

    Not required on buses less than 30 feet long

C-13

STOP ARM:

C-17

____

  • 1.

    The stop arm should be on the left side near front cowl section

  • 2.

    Octagon-shaped, constructed of zinc-coated steel, aluminum, or equivalent material of equal

durability

  • 3.

    One-half inch white border

  • 4.

    The word “STOP” in "6" white letters (both sides) with red background

  • 5.

    Letters, border, and background shall be of reflective material

  • 6.

    2 double-faced red, alternately flashing lamps (1 top and 1 bottom)

Section G-6

Document info
Document views234
Page views234
Page last viewedWed Dec 07 12:36:53 UTC 2016
Pages97
Paragraphs2216
Words30825

Comments