X hits on this document

279 views

0 shares

0 downloads

0 comments

84 / 97

____

ALARM, Backup: 1. Automatic, audible warning that the bus is in reverse gear, located behind the rear axle 2. Meet SAE J994 requirements and be 107dba minimum sound level

C-3

____

ACCESS, Entry/Aisle: 1. 12” between seats 2. 30” aisle width from wheelchair position to one emergency door

C-2 D-2

____

BODY FLUID CLEAN-UP KIT: 1. Securely mounted in the driver area, but easily removed without tools 2. Labeled as a body fluid clean-up kit. (See Spec for contents) 3. Moisture-proof hard plastic kit 4. No display of the biohazard symbol

C-5

____

COVERING/MOLDING, Floor: 1. Aisle- .187” (3/16) thick ribbed rubber or equivalent 2. Other areas-.125 (1/8”) thick rubber 3. Driver’s compartment and toe board covering held in place by molding/trim strip (3/16’ x 1’’) 4. Permanently bonded to floor and must not crack 5. Metal strips between aisle and area under the seats 6. Flat or low profile oval head screws in countersunk holes, not more than 9” apart and within ¾” each end. (9½” okay, but only to avoid floor sill members) 7. Seams shall be covered using aluminum or stainless steel trim and countersunk screws 8. Seams sealed with waterproof sealer

C-7

EMERGENCY EXITS:

C-6

  • *

    Dual stop arms required on 47 pass and larger (optional for less than 47 pass), the second sign goes on the left side near rear section. Stop arm shall have one "STOP" emblem facing the rear of the bus.

____

  • 1.

    Buzzer to sound in driver’s compartment when unlatched

  • 2.

    “Emergency Door” or “Emergency Exit” in 2” high black painted letters at top or over door

  • 3.

    Handle in aisle area to meet FMVSS 217 requirement

  • 4.

    Operating instructions near handle

Section G-7

B-7

(7) INSIDE

____

BUMPER, Rear: 1. Pressed steel channel 2. 3/16” x 9 1/2” minimum (unless chassis manufacturer’s standard on 15-20 pass buses) 3. Bolted to chassis frame and braced 4. Not permanently attached to body 5. Wrap around body design 6. Contour designed to prevent hitching to or riding on bumper 7. Painted black 8. Apply seal between bumper and body panel unless gap is 1/8’ or less

____

LICENSE PLATE HOLDER: 1. Means to mount the license plate on front and rear of the bus body 2. Items added to the bus must not obstruct the location of the front license plate 3. Illuminated (Rear plate only)

____

TIRES, Dual Rear: (Single rear wheels are not allowed) Steel belted radial tubeless type

(6) OTHER

C-2

C-9

Document info
Document views279
Page views279
Page last viewedSun Dec 11 00:41:49 UTC 2016
Pages97
Paragraphs2216
Words30825

Comments