X hits on this document

351 views

0 shares

0 downloads

0 comments

88 / 97

  • 4.

    Insulated and in fibrous loom or equal

  • 5.

    Connections by soldering or by industry approved connectors

(8) UNDERNEATH

____

ABSORBER, SHOCK: All heavy duty

  • 1.

    Front and rear, double acting

  • 2.

    Adequate size for axle load

B-6

____

BRAKES, Air: 1. Required as standard on all 59 thru 90 passenger buses 2. Automatic air dryer 3. Air dryer shall have a replaceable filter with access to replace filter without removing or loosing B-3

the air dryer assembly bolts

____

CROSS-MEMBER, Floor: Spaced not more than 10 inches center-to-center, except on Type A buses.

C-6

FRAME SIDE MEMBER:

B-5

____

1. Each frame side member shall be of one-piece construction between rear and forward spring hanger 2. Extensions are permissible only when such alterations are welded behind rear spring

3. Wheel base extensions are not permitted

____

GUARD, Drive Shaft: Required for each drive shaft section

B-4

____

SYSTEM, Exhaust: 1. Must be under the bus body and attached to chassis frame

B-5

2. If exhaust system is less than 12” from fuel tank or if the tail pipe is located under the fuel filler opening, a metal shield must be installed. (see Specs. for details) 3. Tail pipe shall extend no more than 2” beyond rear bumper

____

TRANSMISSION: All bus sizes to be equipped with manufacturer’s standard automatic transmission unless otherwise specified

____

UNDERCOATING: C-18 1. 1/8” thick, asphalt base 2. Entire underside including floor, step well, wheel wells, side panels below floor level, and metal fenders 3. Inside of exposed exterior panels, after panels installed

B-7

(9) GENERAL

____

HANDICAPPED EQUIPMENT:

  • 1.

    Forward facing orientation

  • 2.

    Four (4) Universal Handicapped Symbols

    • a.

      One each on the front and rear of the bus

    • b.

      Both sides of the bus below the window line

  • 3.

    White on blue background, 12” maximum

D-7 D-6

____

WHEELCHAIR LIFT: 1. Lift and platform shall be capable of operating effectively while lifting at least eight hundred

  • (800)

    pounds

  • 2.

    See FMVSS 403/404 Certification Checklist

D-3

G-13-14

Section G-11

Document info
Document views351
Page views351
Page last viewedSat Jan 21 23:40:14 UTC 2017
Pages97
Paragraphs2216
Words30825

Comments