X hits on this document

196 views

0 shares

0 downloads

0 comments

91 / 97

Standard Wheelchair Lift Inspection Checklist

  • -

    Continued

Maxon & Braun Lifts Only:

Step onto the platform with both feet. Ride the platform down to the ground until the Outboard Roll-stop is completely open. Stand on the Outboard Roll-stop, and activate the UP button until the Lift stops.

Make sure that the Lift did not raise more than 3" before it stopped. The Outboard Roll-stop must not fold while you are standing on it.

Ricon Lifts Only: Unfasten the safety belt while lowering the Lift platform. Make sure that the Lift stops when you unfasten the safety belt. Make sure that you can not raise or lower the platform until the safety belt is fastened.

All Lifts:

Raise the platform to the floor level. Note the number of lifts on the operations counter. __________ Lower the Lift all the way to the ground, and then raise the Lift all the way to the floor. Again note the number of lifts on the operations counter. __________

Make sure the lower/raise function was counted on the operations counter.

Vehicle I.D. (VIN) # : ______________________________________ Wheelchair Lift Serial # : __________________________________ Checked By: ___________________________________________ Date: _________________________________________________________

NOTE: If the lift does not pass this inspection, it is recommended that it not be placed in service and that you contact your vehicle dealer.

G-14

Document info
Document views196
Page views196
Page last viewedFri Oct 28 20:16:13 UTC 2016
Pages97
Paragraphs2216
Words30825

Comments