GL1800 #19 DECEMBER 2006
American Honda Motor Co., Inc.
2006 GL1800 Airbag CB Radio Squeal
Some 2006 GL1800 Airbag models equipped with the optional accessory CB radio may expe- rience a squealing noise when transmitting.
To remedy this problem, a ferrite core harness kit is now available for installation.
Subharness installation can be confirmed by removing the left-side fairing pocket, and check- ing to see if the harness is already installed.
2006 GL1800 VIIIA (Airbag models) with optional CB Radio.
Install a ferrite harness core kit according to the installation instructions that are packaged with the kit.
The kit includes both a rider and a passen- ger harness; its necessary to install both harnesses to eliminate the squealing noise.
Passengers must route the headset cord as shown. If routed otherwise, it will be too close to the motorcycles antenna, which can create an interference.
6-PIN CONNECTOR (RED)
FERRITE CORE HARNESS
Ferrite Core Harness Kit (1 required) P/N: 08E95-MCA-100WA H/C: 8607665
Call TechLine at (800) 421-1900 to
order parts. Due to the limited number of affected units and parts availability, ordering will be controlled until May 31, 2007.
Normal warranty claim submission require- ments apply. Submit one claim per VIN. Template: GL19 Flat Rate Time: 0.3 hours
1 of 1
©2006 American Honda Motor Co., Inc. All Rights Reserved
MTB 11809 (0612)
CUSTOMER INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely maintain your Honda. These procedures should not be attempted by "do-it-yourselfers," and you should not assume this bulletin applies to your Honda, or that your Honda has the condition described. To determine whether this information applies, contact an authorized Honda dealer.