X hits on this document

182 views

0 shares

0 downloads

0 comments

5 / 56

ProRace Hose

Premium Performance Aerospace Hose Used By Hard Core Racers

For superior fluid compatibility and temperature range, select the ProRace hose. It’s specially formulated CPE synthetic inner liner is embedded with a partial coverage stainless steel inner braid, then bonded together by a full coverage stainless outer braid. This combination guarantees the optimum in bonding charactertistics while maximizing hose flexibility. Lightweight for better power to weight ratio.

  • Rugged stainless steel jacket resists abrasion

  • Flow rate is consistent throughout the operating range

from - 0˚F to +350˚F

Size

I.D.

I.D.

PSI

Foot

Roll

Roll

-

7/32”

1/ ”

1500

3280

3286

3287

-6

11/32”

3/8”

1500

3281

3288

3289

-8

7/16”

1/2”

1500

3282

3290

3291

-10

9/16”

5/8”

1250

3283

3292

3293

-12

11/16”

3/ ”

1000

328

329

3295

  • Compatible with all hydrocarbon and alcohol based fuels, lubricants and additives thus eliminating deterioration and leakage caused by inferior grade hoses

  • Works with all adapter fitting sizes of - , -6, -8, -10, -12 &

    • -

      16 for all applications

  • Use with Full Flow™, Endura Full Flow™ and Tube Seal™ hose ends (see pages 8 - 10, 51)

Actual Nominal Max

Per

10

20

  • -

    16

7/8”

1”

750

Hose Installation Tips

3285 3296 3297

Secondary Rubber Jacket Increases Overall Flexibility.

Right

Wrong

Wrong

Right

Avoid installing the hose in a twisted position. This can weaken your assembly as well as under pressure tends to loosen fitting connections.

When routing the hose assembly provide a smooth bend radius. Avoid sharp bends, which will collapse the hose I.D., thus restricting flow. Exceeding minimum bend radius will reduce hose assembly life.

308 Stainless Wire Braid Outer Construction Provides Durability and Resists Heat.

Inner Rubber Jacket Is Woven With Wire Brading For Wider Angle Application and More Flexibility.

Superior Bonding Eliminates Hose Fraying When Cut.

Inner Liner Made From Chlorinated Polyethylene.

Right

Wrong

Allow slack in your hose assembly for changes in length that occur under pressure. This allows your hose to absorb the energy, not your connections.

5

Document info
Document views182
Page views184
Page last viewedWed Dec 07 18:36:24 UTC 2016
Pages56
Paragraphs5786
Words21418

Comments