X hits on this document

180 views

0 shares

0 downloads

0 comments

50 / 56

50

Hose Sleeving

FlexGuard™ Hose Sleeving

FlexGuard™ Hose Sleeving is an economical way to dress up your engine compartment without the expense of stainless steel hose. It is designed for easy slip-over installation on existing hoses. FlexGuard™ Hose Sleeving delivers both appearance and added reliability. Used in conjunction with Russell Tube Seal™ Hose Ends to duplicate the appearance of professional racing hoses and fittings.

  • Duplicates the appearance but not the cost of stainless steel braided hose

  • Easily fits over existing hoses

  • Fits hose si es from 3/16” O.D. to 2 1/2” O.D.

  • Easily cuts to length with scissors

  • Sold in 3 ft. and 6 ft. lengths

  • To be used in conjunction with Tube Seal™ Hose Ends (page 51)

3/16” - 3/8”

Vacuum Lines, Spark Plug Wires

1008AR

1008BR

1/2” - 7/8”

Fuel Lines, PCV Overflow Hoses

2008AR

2008BR

3/4” - 1 1/4”

Heater Hoses, P/S Hoses, A/C Lines

3008AR

3008BR

1 1/4” - 1 5/8”

Small Radiator Hoses

4008AR

4008BR

1 1/2” - 2”

Medium Radiator Hoses

5008AR

5008BR

2” - 2 1/2”

Large Radiator Hoses

6008AR

6008BR

O.D. Range

Application

Part # – 3’ Pkg.

Part # – 6’ Pkg.

How To Install Sleeving

STEP 1: Unroll sleeving but do not ut before installation onto the hose.

STEP 2: Expand the sleeving by putting your finger inside and pushing toward your hand. Expand enough to over your hose.

STEP 3: Slide sleeving onto your hose. Keep the sleeving expanded, working it down the hose slowly until it is ompletely overed. Run the sleeving approximately 1/2” past the end of the hose.

STEP 4: Wrap tape around the end of the hose to se ure the sleeving. Pull the sleeving tight. Tape the other end. Now ut the sleeving from the roll using s issors. Trim both ends.

STEP 5: Take the Tube Seal™ ends, tighten hose lamp down as small as possible and insert inside of Tube Seal™, then open up lamp to expand Tube Seal™ and slide onto hose past the tape ends. Slowly remove the tape from the hose, slip over the fitting, slide the Tube Seal™ end into position, tighten se urely.

Document info
Document views180
Page views182
Page last viewedTue Dec 06 22:05:03 UTC 2016
Pages56
Paragraphs5786
Words21418

Comments