X hits on this document

173 views

0 shares

0 downloads

0 comments

7 / 56

PowerFlex™ Power Steering Hose

Stainless Braided Hose For High Pressure Power Steering Lines

For high pressure power steering lines, PowerFlex™ Power Steering Hose is the preferred choice. When used in conjunction with Russell’s PowerFlex™ hose ends, the end result is a durable and professional hose that resists leaks, providing years of service. A choice of power steering adapters are available to allow the connection to most pumps, feed, pressure and return lines.

  • Teflon® inner liner with a 308 stainless steel braid

  • Hose is rated at 2500 psi

  • Use with super strength high alloy steel PowerFlex™ Hose Ends for enhanced reliability (see page 12)

  • Select the appropriate power steering adapter to complete the assembly (see page 12)

Size

Hose I.D.

Max PSI

Per Foot

3’ Roll

-6

11/32”

2500

3259

3260

-8

7/16”

2500

3071

3266

-10

9/16”

2500

3270

3271

How To Assemble PowerFlex™ Hose To PowerFlex™ Hose End

STEP ONE: Wrap the hose tightly with electrical tape. Hold the hose firmly in a vise without crushing and cut through the tape. Make sure you make a straight cut. Remove the tape slowly and deburr the teflon edges. Install the socket on the hose and slide it back out of the way.

STEP TWO: Insert the nipple portion of the PowerFlex hose end in a vise. Slip the hose over the nipple in a twisting motion to size the I.D. of the teflon. Separate the wire braid from the O.D. of the teflon tube with a small screwdriver. Be careful not to crush the teflon.

STEP THREE: Push the olive sleeve around the teflon and between the braid. This can be done by pushing the olive sleeve against the side of your work- bench or vise. Be sure the teflon liner is square to the bottom of the olive. With the nipple in the vise, lube the threads and the nipple portion of the hose end sparingly. Insert the hose over the nipple making sure the olive does not pop off the teflon tube.

6’ Roll

10’ Roll

3261

3262

3267

3268

3272

3273

STEP FOUR: Start the socket onto the nipple by hand. Tighten with a wrench until the gap between the nipple and the socket is no more than 1/16”. Clean the hose assembly and pressure test before using.

7

Document info
Document views173
Page views175
Page last viewedMon Dec 05 10:14:42 UTC 2016
Pages56
Paragraphs5786
Words21418

Comments