X hits on this document

PDF document

WEDNESDA , APRIL 13 - MORNING Technical and Business Sessions - page 82 / 100

385 views

0 shares

0 downloads

0 comments

82 / 100

poWertrain/propulsion

New CI & SI Engines and Components (Part 2 of 3) (PFL500)

Powertrain Control and Optimization (Part 2 of 3) (PFL300)

SI Combustion (Part 2 of 3) (PFL201)

Transmission and Driveline: Controls (PFL604)

This session covers topics regarding new CI and SI engines and components. This includes analytical, experimental, and computational studies covering hardware development as well as design and analysis techniques.

This session covers engine control system and optimization technique developments related to achieving stringent market fuel economy, emissions, performance, reliability and quality demands. Related topics include engine and its subsystem control, signal processing, on-board diagnostic strategy development, sensor, actuator, electronic control unit designs, etc.

This session focuses on combustion technologies in both 4-stroke and 2-stroke engines characterized by 1) ignition by an external energy source that serves to control combustion phasing, and 2) a combustion rate that is limited by flame propagation. Gasoline and alternative fuels are considered. The scope of topics includes studies of mixture formation, ignition, knock, engine efficiency, flame propagation, and emissions formation. Part 2 of 3: Boosted Engine Combustion, Pre-ignition & Knock

This session covers transmission and driveline controls. Topics related to controls hardware, controls software, and controls integration are covered.

1:00 p.m. - 3:00 p.m.

1:00 p.m. - 3:40 p.m.

1:00 p.m. - 3:20 p.m.

1:00 p.m. - 3:20 p.m.

W2-70

TIME

W2-64

TUESDA , APRIL 12 - AFTERNOON Technical and Business Sessions

SESSION TITLE, DESCRIPTION, AND ROOM

W2-69

W2-63

Integrated Simulation of Engine Performance and AFR Control of a Stoichiometric Compression Ignition (SCI) Engine

Ignition Delay Correlation for Predicting Autoignition of a Toluene Reference Fuel Blend in Spark Ignition Engines

(2011-01-0698)

(2011-01-0338)

hai Wu, Xinlei Wang, Univ. of Illinois at Urbana-Champaign; Richard Winsor, Kirby Baumgard, John Deere Power Systems

Asim Iqbal, Ohio State Univ.; Ahmet Selamet, Ohio State Univ; Ronald Reese, Chrysler; Roger Vick, Chrysler Powertrain Engrg

3:20 p.m.

Organizers: hussein Dourra, Chrysler Group LLC; Erich L. Wilfinger, Jatco USA Inc.

h Pandarinath, J Sureshkumar, Ramalingam Sivanantham, S Prabhakar, S R Nagendiran, UCAL Fuel Systems Ltd.

Organizers: Richard S. Davis, General Motors Powertrain

(2011-01-0411)

10:02 p.m.

10:03 p.m.

Coolant Pipe Press Fit Study (Written Only

  • --

    No Oral Presentation)

(2011-01-0421)

V. A. Muruganandam, Maruthi Dhulipudi, GM Technical Center India Ltd. - General Motors Company; Uday Korde, General Motors Company

Organizers: Jeffrey D. Naber, Michigan Technological Univ.; James E. Smith, West Virginia Univ.; John Szpytman, Continental Automotive Systems US Inc.

Organizers: Peter J. Maloney, The MathWorks Inc.; Matti Vint, Ricardo Inc.

10:01 p.m.

Numerical and Experimental Investigation of Airflow through Check Valve of Vacuum Pump for Automotive Application (Written Only -- No Oral Presentation)

Development of Analytical Model for Design of Gerotor Oil Pump and Experimental Validation (Written Only -- No Oral Presentation)

(2011-01-0402)

P. Lingeswaramurthy, UCAL Fuel Systems, Ltd.; J. Jayabhaskar, R. Elayaraja, J. Suresh Kumar, UCAL Fuel Systems Ltd.

Planned by Lubricants and Powertrain Systems Committee / Powertrain Fuels and Lubricants Activity

Planned by Control and Calibration Committee / Powertrain Fuels and Lubricants Activity

Planned by Combustion and Fuels Committee / Powertrain Fuels and Lubricants Activity

Planned by Transmission and Driveline Committee / Powertrain Fuels and Lubricants Activity

The papers in this session are available in SAE Technical Paper Collection, COLL-TP-00167, and also individually. To purchase visit collections.sae.org

The papers in this session are available in SAE Technical Paper Collection, COLL-TP-00175, and also individually. To purchase visit collections.sae.org

The papers in this session are available in SAE Technical Paper Collection, COLL-TP-00151, and also individually. To purchase visit collections.sae.org

The papers in this session are available in SAE Technical Paper Collection, COLL-TP-00170, and also individually. To purchase visit collections.sae.org

Technical Session Oral Evaluation Incentives

In an effort to collect more evaluation ratings for the technical session speakers, SAE will be holding daily drawings for anyone who completes an oral evaluation card distributed in technical session rooms. Simply complete the card, tear off the perforation with your name and contact number, and turn it in to the session moderator. Three (3) winners will be announced daily to receive $50 gift certiÓĀôcates. Winners will be announced daily and posted in the technology lounges.

130

SAE 2011 World Congress

Document info
Document views385
Page views385
Page last viewedSat Dec 03 00:36:34 UTC 2016
Pages100
Paragraphs7750
Words67338

Comments