X hits on this document

PDF document

DEVONSHIRE SINGLE DOOR CABINET INSTRUCTIONS - page 2 / 8

15 views

0 shares

0 downloads

0 comments

2 / 8

Install screws through holes in cabinet as shown in Fig. 1 DO NOT OVERTIGHTEN! Use SS328 #8 x 1 1/2 Phillips head.

Top View

Fig. 1

Stud and wall surface

Cabinet flange fits flush against wall.

Install dome caps over screws.

  • 2.

    Surface Mounting the Cabinet on the Wall.

    • A.

      Install Mounting Bar

  • 1.

    Drill two 3/16” holes in bottom mounting bar at indent location.

Use supplied anchors or locate studs if possible.

Fig. 2

4 1/2" from edge of cabinet.

3/4"

Bottom of Cabinet

  • 2.

    Drill 3/16” hole in wall for mounting bar anchors at locations shown in Fig. 2. ( If you do not use the anchor, drill a 3/32” pilot hole.) After the holes are drilled, fit the mounting bar onto the wall, refer to Fig. 2 for measurements, and Fig. 4 for information on anchor cinching.

    • B.

      Install Top Clips

(Left and right top clips come connected, hold both clips and snap them apart).

  • 1.

    Fit cabinet into position on mounting bar as shown in Fig. 3A.

  • 2.

    Place clip in position as shown in Fig. 3B and mark with a pencil. Remove clip and cabinet and drill the pilot or anchor holes where marked.

  • 3.

    Fix both the clips into position with a screw, and slide the clip into the up position. Sit the cabinet on the mounting bar, then lower and tighten the screws into place, as shown in Fig 3B.

  • 4.

    See Fig. 4 for proper turns required for anchor cinching.

  • 5.

    See page 3 for side kit application.

INSTALLER’S NOTE: Installing the cabinet on a wall without the door attached can make installing easier for one person. Do not mount the doors until the box is in or on the wall.

209-1019 Devonshire Cabinet

Fig. 3A

Cabinet bottom sits in lip on bottom mounting bar

#8 x 2" Hex head screw & Wall anchor (use 1/4" driver)

11" bottom mounting bar

Fig. 3B

Wall anchor (if required)

Top mount clip

#8 x 2" Hex head screw (Use 1/4" driver)

Fig. 4

Once Screw is bottomed out on mount clip, turn screw an additional 5 to 7 turns to fully expand the anchor.

Side view at top of cabinet

Document info
Document views15
Page views15
Page last viewedMon Dec 05 07:31:40 UTC 2016
Pages8
Paragraphs316
Words3098

Comments