X hits on this document

PDF document

DEVONSHIRE SINGLE DOOR CABINET INSTRUCTIONS - page 3 / 8

18 views

0 shares

0 downloads

0 comments

3 / 8

  • 3.

    Attaching Side Kits to a Surface Mounted Cabinet

    • 1.

      Apply foam tape to Side kit bracket

      • A.

        Peel tape from sheet, leave liner on.

      • B.

        Apply as shown to side kit brackets, be sure they are clean and dry.

      • C.

        DO NOT PEEL RELEASE LINER UNTIL YOU HAVE TEST FIT THE SIDE KITS ON THE CABINET!

  • 2.

    Attach the side kit brackets to the cabinet as shown in Fig. 5

  • 3.

    Test fit the side kits, then clean the back of the side kits with rubbing alcohol.

  • 4.

    Peel the release tape from the brackets and apply the side kits, push firmly

to set. 5. Cover the screw heads with the screw caps.

Fig. 5

Align top of side kit with top of flange

Side kit bracket

(Fits tight under the flange of cabinet)

#8 x 3/8" screws self thread into Side Kit brackets

2 pieces 26" high

Side Kit brackets

  • 4.

    Door adjustments

    • A.

      This screw releases the door from the cabinet and allows up and down adjustment.

8-32 x 1/2" (SS829)

6-32 x 3/8" (SS679)

B. These screws allow you to plumb the door as shown in Figure 6.

Fig.6

209-1019 Devonshire Cabinet

Document info
Document views18
Page views18
Page last viewedThu Dec 08 04:27:40 UTC 2016
Pages8
Paragraphs316
Words3098

Comments