X hits on this document





21 / 66

Setting Up Your HP iPAQ

Use the following steps to quickly set up your HP iPAQ and connect it to your personal computer. The illustrations in the previous sections display the specific location of the HP iPAQ components.

Step 1: Remove the Battery Cover and Slide In the SIM

  • 1.

    On the back of the HP iPAQ, press in on the battery cover latch.

  • 2.

    With your thumb, slide the battery cover down and away from the device. NOTE If the battery is already installed, remove it before inserting the SIM card. The SIM card is provided by the mobile phone service provider. The SIM card may already be preinstalled in your HP iPAQ.

  • 3.

    Align the notched corner on the card with the notched corner in the SIM slot.

  • 4.

    With the metal contacts facing down, slide the SIM card horizontally into the SIM slot. Push it in until it stops.

Step 2: Install the Battery and Replace the Battery Cover

1. Align the battery connectors on the battery with the housing pins in the battery compartment and insert the battery.

NOTE Be sure the pull tab is exposed so the battery can be easily removed.

2. Slide the battery cover on until it clicks into place. Step 3: Charge the battery

CAUTION To avoid damaging your HP iPAQ or the AC adapter, be sure all connectors are properly aligned before connecting.

The battery provides power for your HP iPAQ to operate. Your HP iPAQ came with either a USB synchronization cable or a USB synchronization cradle/charger, which you must use to charge the device.

It takes about four hours to fully charge the battery.


Document info
Document views215
Page views215
Page last viewedMon Jan 16 22:31:46 UTC 2017