X hits on this document

156 views

0 shares

0 downloads

0 comments

44 / 48

44

Measurements and analysis with the VAS 5051

Your attention must finally be drawn to the fol- lowing points for evaluation of displayed curves which deviate greatly from one of the preset curves:

  • -

    Only curves recorded under the same condi- tions or prerequisites can be compared with one another

  • -

    Fluorescent lamps may produce interfering signals

  • -

    The ignition transformer and leads emit inter- fering signals which may be superimposed on the actual curve or falsify it.

The curves shown here are examples which can- not be used as correct curves for fault finding.

If the DSO test probes are not connected correctly, it may occur that interfering signals from the ignition system are displayed, and not the expected sender or actuator signal.

Test Instruments DSO

Auto level mode

0,2 V/Div.=

50 ms/Div.

Freeze Frame

Channel A

Channel B

Trigger mode

Measuring mode

0

Coupling

Preset

measurement

Go to

Print

Channel

Help

  • -

    0,16

Multimeter

202/078

The displayed curve shows the typical wave- shape of interference from illumination by fluorescent lamps.

The interfering curve is superimposed on the measured curve, and changes the overall curve.

Document info
Document views156
Page views156
Page last viewedTue Jan 17 12:52:37 UTC 2017
Pages48
Paragraphs1514
Words8658

Comments