X hits on this document

Word document

Department of Environmental Protection - page 27 / 48

124 views

0 shares

0 downloads

0 comments

27 / 48

06-096DEPARTMENT OF ENVIRONMENTAL PROTECTION

followed unless modified by the Department.

(b)Biomass and fossil fuel boiler ash.

(i)prior to initial acceptance at a solid waste facility, a sufficient number of samples to meet the requirements for statistical analysis as required by US EPA SW-846 must be analyzed as follows:

a.TCLP Metals (Arsenic, Barium, Cadmium, Chromium, Lead, Mercury, Selenium, Silver) per US EPA Method 1311, Federal Register/Volume 55, No. 126;

b.For beneficial use only, total Aluminum, Arsenic, Barium, Boron, Cadmium, Chromium, Copper, Lead, Mercury, Molybdenum, Nickel, Selenium, Silver, Vanadium, and Zinc per methods in US EPA SW-846;

c.For fossil fuel boiler ash only, Total Vanadium; and

d.Chloride, percent carbon, percent moisture, pH, phosphorus.

(ii)after initial characterization is complete, each biomass and fossil fuel source must be analyzed for the parameters listed above at a frequency of one representative sample quarterly, or one annually for those sources that generate less than two hundred (200) tons per year.

(c)Wood boiler ash.

(i)prior to initial acceptance at a solid waste facility, a sufficient number of samples to meet the requirements for statistical analysis as required by US EPA SW-846 as follows:

a.TCLP Metals (Arsenic, Barium, Cadmium, Chromium, Lead, Mercury, Selenium, Silver) per US EPA Method 1311, Federal Register/Volume 55, No. 126 ;

b.For beneficial use only, total Cadmium, Chromium, Copper, Lead, Mercury, Nickel, Zinc per methods in US EPA SW-846; and

c.Chloride, percent carbon, percent moisture, pH, phosphorus.

(ii)after initial characterization is complete, each wood boiler ash source must be analyzed for the parameters listed above at a frequency of one representative sample quarterly, or one annually for those sources that generate less than two hundred (200) tons per year.

(d)Ash from the open burning of wood waste, and unpainted or painted wood from construction or demolition debris. Prior to initial acceptance at a solid waste landfill facility, ash from the open burning of wood waste from each source must be analyzed by the TCLP for metals (per US EPA Method 1311, Federal Register/Volume 55, No. 126) at the following frequencies:

(i)once per year for those sources that generate less than ten (10) tons annually,

(ii)semi-annually for those sources which generate ten to twenty-five (10-25) tons annually, and

(iii)quarterly for those sources that generate greater than twenty-five (25) tons annually.

Chapter 405: Water Quality Monitoring, Leachate Monitoring, and Waste Characterization

- 25 -

Document info
Document views124
Page views124
Page last viewedTue Dec 06 16:57:41 UTC 2016
Pages48
Paragraphs1570
Words17167

Comments