X hits on this document

113 views

0 shares

0 downloads

0 comments

13 / 59

Vibration in shipping can cause some bolts or screws to loosen up. Before using your new machine, check the tightness of all fasteners. It is also a good idea to check tightness periodically when using the machine, as vibration from operation may cause some fasteners to loosen up.

Mounting the motor and speed control unit to the headstock

(Refer to the exploded views and number list for part number references.)

FIGURE 6-DC Motor and Speed Control Assembly

  • 1.

    Remove motor pulley from motor shaft. Mount the inner belt guard to the motor using the two standoffs (P/N 4310). Next install the motor pulley (P/N 4336) to the motor shaft and tighten the set screw. The end of the pulley should be just about even with the end of the motor shaft with the smaller pulley toward the end of the shaft.

  • 2.

    Place drive belt over motor pulley.

  • 3.

    Place round post on speed control hinge plate in hole on inner belt guard.

  • 4.

    Set outer belt guard in place locating other post of hinge plate in its pivot hole. Motor standoff ends will register in holes in outer belt guard. Make sure the drive

Document info
Document views113
Page views113
Page last viewedMon Dec 05 11:03:01 UTC 2016
Pages59
Paragraphs677
Words15435

Comments