X hits on this document

149 views

0 shares

0 downloads

0 comments

44 / 59

FIGURE 13-3/8" End Mill Holder

3/8" END MILL HOLDER (P/N 3079)

The 3/8" end mill holder makes it easy to use the popular (and less expensive) 3/8" end mills. Using double ended end mills is economical and easy with this holder as tools are changed by simply loosening a set screw and changing the tool. The holder is now also available to hold smaller size tools in the same manner. The 3/16" end mill holder is P/N 6080 and the 1/4" end mill holder is P/N 6079.

FIGURE 14-3/8" End Mill Holder

MILL COLLET SET (P/N 3060)

The main purpose of the mill collet set is to hold end mills. The spindle nose has an internal Morse No. 1 taper, which closes the collet as the drawbolt is tightened. Morse tapers are approximately 5/8" per foot and are self-locking. Therefore, to loosen a collet, the drawbolt must be loosened a few turns and given a few light taps with a hammer.

BORING HEAD (P/N 3054) AND BORING TOOLS

The main purpose of the boring head is to eliminate the need for a large inventory of drills and reamers. A small milling machine would not have the power or rigidity to turn

Document info
Document views149
Page views149
Page last viewedSun Dec 11 10:44:55 UTC 2016
Pages59
Paragraphs677
Words15435

Comments