X hits on this document

PDF document

EPSON PRODUCT SUPPORT BULLETIN - page 10 / 28

77 views

0 shares

0 downloads

0 comments

10 / 28

After the firmware file has been copied to the memory card, insert the Compact Flash or SD memory card into the viewer.

Press and hold down the “OK” and

keys while sliding the “POWER” switch as shown below.

Warning: Do not turn off the viewer or attempt to remove the battery or disconnect the AC adapter at any time during the firmware update.

When you see the EPSON logo name, release the OK and will begin and take approximately 3.5 minutes to complete.

keys; the main firmware update

NOTE: The Sub CPU firmware update is not installed in this version. Do not be alarmed if the Sub CPU firmware update says “not available….” Once the firmware update is completed you should see this screen.

Power off the viewer and remove the Compact Flash or SD memory card. Then turn the viewer back on. Note: Do not press any keys when turning on the unit.

Set the Date and Time if prompted.

On the Home screen, press the Menu key. Select [Settings], then [Delete all cache files]. Press OK. If you see a dialog box prompting you to connect the AC adapter, click OK. You will then see a progress bar until the process is completed.

Open Settings from the Home screen and select Device Information. In Device Information select Firmware Version. The new firmware version “02.51.0325-0110-0200-0123” will be

Page 4 of 5

PSB.2010.06.001

Document info
Document views77
Page views77
Page last viewedWed Dec 07 11:00:14 UTC 2016
Pages28
Paragraphs800
Words7493

Comments