X hits on this document

PDF document

EPSON PRODUCT SUPPORT BULLETIN - page 6 / 28

78 views

0 shares

0 downloads

0 comments

6 / 28

2. Insert memory card into viewer.

3. 4.

Turn on viewer with RATE ( “Main F/W Update” message

) + DISPLAY pressed. is displayed, and release

key

when

you

see

the

memory

card access LED blink.

  • 5.

    It takes about 4 minutes, then “Please turn off” message is displayed. The viewer will be turned off automatically.

  • 6.

    Turn it on again, and if you see the HOME screen, recover has completed. There is no need for any further updates.

If the update does not start, please check following and do the update again:

  • 1.

    Check to see if the SD / CF memory card is defective or not.

  • 2.

    Check whether the CF card capacity is 16GB or larger.

  • 3.

    Check “PSV5FIRM” folder existence in memory card root folder.

Please check the following if you see a different message:

  • 1.

    Check whether the AC adapter is connected, and AC power is correctly supplied.

  • 2.

    Check battery insertion.

  • 3.

    Check whether the SD card is formatted by the SD supporting device.

  • 4.

    Check whether the folder “PSV5FIRM” folder has “PSV50260.FNC” file.

  • 5.

    Check whether the “PSV50260.FNC” has 8,000 KB in size.

Check the following if the updated version is different:

  • 1.

    If the version is displayed as “02.60.0325-0108-0107-0124”, then the 2.60 update was executed on a viewer that had a firmware prior to the Ver 1.57 firmware update.

  • 2.

    Please perform the firmware update Ver 1.57, and re-perform Ver 2.60 firmware update again.

  • 3.

    If the version is displayed as “02.60.0325-0108-0200-0124 or 02.60.0325-0110-0107- 0124”, please update the Ver 1.57 firmware again, then perform Ver 2.60 again.

Page 6 of 6

PSB.2012.01.001

Document info
Document views78
Page views78
Page last viewedWed Dec 07 11:23:21 UTC 2016
Pages28
Paragraphs800
Words7493

Comments