Check all lights for proper operation.
Check the tightness of all fasteners that have been
involved in this installation
The high quality chrome finish of your National Cycle light bar can be maintained with any quality chrome cleaner and /or polish.
Replacement bulbs and bulbs for the turn signals can be found at motorcycle and accessory dealers as well as auto- mobile parts stores, or by calling National Cycle.
Description Light Head Assembly Right Side Left Side
N942 Part No.
N942E Part No.
SealedBeam Bulb Only For Above
Order replacement parts through your local dealer or contact National Cycle.
Turn Signal Bulb Only: Bulb 1157 Available at Most Auto Parts Stores.
Lamp Assembly E13/DOT
Reflector, Lens a
Turn Signal Assembly
Turn Signal Lens
1. Aim the driving lamps. Each lamp should shine straight ahead or slightly to the right of the motorcycle. The top of the lamp beam should be just below the center of the lamp at a distance of 25’
2. To correctly aim the driving lamps: Stand the motorcycle in an upright position.
Turn the motorcycle main switch to on.
Turn the driving lamp switch to on.
Loosen each driving lamp post nut and aim the driving
lamp beam as shown. Item D.
6. Tighten each post nut and check each lamp for correct aim.
Installing optional N9005 Light Head Visor. 1. Loosen the rim of the light head assembly. (Phillips Screw Driver).
Slip taps of Visor under rim. Item E.
Shape visor / Visor Tabs to conform to contours of light
head assembly. 4. Retighten rim.
To adjust vertical aim you will need: 3/4” Open Ended Wrench (19mm)
©2001 National Cycle, Inc. PO Box 158, Maywood, IL 60153-0158 USA 708-343-0400 / Fax: 708-343-0625 / www.nationalcycle.com / e mail: firstname.lastname@example.org
Page 2 of 2
10-110742-000 06/01 Rev B 03/05