SOLID WASTE PROCESSING AND DISPOSAL
Rule 1200-01-07-.04, continued)
Typical cells and lifts and associated berms and dikes and on-site roadways;
The configuration of the final cover system (including any required cap), including slopes; and
The configurations of any gas migration control features.
Narrative Description of the Facility and Operations - The Part II permit application must include, with appropriate references to the engineering plans and hydrogeological report, a narrative which clearly:
Identifies the name of the individual responsible for operation and maintenance of the facility;
Describes the location of the facility using roads and highways;
Describes paragraph addressed
its compliance with all applicable buffer zone standards listed in
(3) of this Rule.
Each buffer zone standard must be
specifically and bodies
of water as reference or
appropriate, and maps otherwise demonstrate
may be attached compliance.
Describes its compliance with applicable siting requirements for fault areas.
Describes its compliance with applicable siting requirements for seismic impact zones.
Describes its compliance with applicable siting requirements for unstable areas.
Describes the barriers, signs, procedures and other measures to be used to
control access to and use of the facility;
Describes the methods and sequence of operation;
Describes the types and anticipated volumes of solid wastes to be disposed of and the sources which generate the waste, and for special wastes, the physical and chemical characteristics of the wastes and any special handling procedures to be utilized;
Identifies the number of acres to be filled and the total number of acres to be permitted, including buffer zone acreage (Note: If the site is to be developed in accordance with a phased development plan, each parcel must be separately addressed. If minimum closure areas are to be utilized such proposal must be described here and delineated in the closure plans);
Describes the waste handling and covering program, to include but not necessarily be limited to, descriptions of:
Unloading, spreading, and compacting operations;
The frequencies and depths of initial, intermediate, and final cover; and
The cover material(s) to be utilized, including the estimated volumes to be
needed (show initial, intermediate, and final earthwork calculations) and their sources and availability.
May, 2010 (Revised)