X hits on this document

PDF document

NISSAN VG30DE(TT) CAM ANGLE SENSOR COUPLING - page 4 / 6

22 views

0 shares

0 downloads

0 comments

4 / 6

5. Mix a small amount of JB Weld (not the Quick Dry version) and apply it in the 2 enlarged dowel holes in the head. Be careful to only apply enough to fill the holes after the dowels are in place.

6. Install the CAS mount with the dowels in it, tighten all 3 bolts completely (12 to 15 ft-lb) and then loosen them just enough to final align the mount.

7. Reinstall the indicator setup and tap on the mount with a plastic hammer until concentricity of .002” TIR or less is achieved. Carefully tighten the mount bolts, rechecking the indicator measurement until all 3 bolts are final torqued to 12 to 15 ft-lb and concentricity is .002” TIR or less. Let the parts setup for at least 15 hours before disassemble.

4

Document info
Document views22
Page views22
Page last viewedWed Dec 07 09:13:13 UTC 2016
Pages6
Paragraphs31
Words1409

Comments