X hits on this document

PDF document

FAA-STC/PMA Approved - page 12 / 27





12 / 27

PXE7300 Series IFE System Installation and Operator’s Manual

After wiring is complete, verify power is ONLY on pin 21 of the connector, and airframe ground on bot- tom connector pin 22. Failure to do so will cause serious internal damage and void PS Engineering's war- ranty.

To install the PXE7300, gently slide the unit into the mounting rack until the hold-down screw is engaged. While applying gentle pressure to the face of the unit, tighten the 3/32" hex-head in the unit until it is se- cure. DO NOT OVER TIGHTEN.

: Do not over-tighten the lock down screw while installing the unit in tray.

  • 1.

    Insert disc, and verify that the player accepts the disk with about ½ of the diameter in the unit. The player should pull the disk smoothly and drop into place.

  • 2.

    The player will begin to play, automatically about 20 seconds (after reading the disc).

  • 3.

    If the unit is in disc mode, with CD inside at power-up, it will play (after reading the disc).

  • 4.

    Verify that all Disc modes operate.

  • 5.

    Push the “Eject” button and verify that the disc is ejected within about 10 seconds.

  • 6.

    Verify radio operation on AM and FM

  • 7.

    Verify that aux audio is presented to the output (if connected).

  • 8.

    Evaluate the audio interface to be certain that the IFE audio is muted during intercom and radio com- munication.

    • a.

      If muting override is provided, evaluate the switch location and verify operation.

    • b.

      Evaluate the audio performance

    • c.

      Evaluate the audio level to verify that the music is adequate under flight conditions.

    • d.

      Evaluate the muting system to demonstrate that the music will be adequately muted if de- sired, by radio and intercom.

    • e.

      Evaluate the muting override control if equipped.

  • 9.

    Evaluate failure remediation from crewmember location

    • a.

      Turn unit off

    • b.

      Locate and pull unit circuit breaker

    • c.

      With the disc playing, with minimum volume, listen to the following audio sources (as equipped), adjusted to normal listening level:

        • i.

          Comm 1, comm. 2, comm 3, HF

      • ii.

        Nav 1, Nav 2

      • iii.

        ADF (1 and 2)

      • iv.

        DME (1 and 2)

        • v.


      • vi.

        Any other audio sources

  • 10.

    Select FM Mode, and repeat step 6, listening for interference on the aircraft audio sources. Pay par- ticular attention to the frequencies listed in table.

  • 11.

    Select AM Mode, and repeat step 6, listening for interference on the aircraft audio sources.

  • 12.

    Select COM 1 for transmit. Tune COM 1 to 118.00, and the PXE7300 to 107.3 MHz. Transmit a test

count and evaluate the unit display and audio output for inconsistencies


Page 2-6

April 2006

Document info
Document views124
Page views124
Page last viewedSat Jan 21 20:16:16 UTC 2017