X hits on this document





112 / 174

Microsoft Windows Logo Program System and Device Requirements  —  112

To support multi-protocol smart cards and smart cards using higher data rates and higher clock frequencies, the reader must support negotiable and specific modes according to ISO/IEC 7816-3 (1997-12-15), Sections 5.4 and 7.

Power Down command for ISO 7816-3 is optional.

PTS is not required.

B5. Support 3.5795 MHz minimum clock frequency.

A smart card reader must support a minimum clock frequency of 3.5795 MHz.

B5. Support minimum data rate of 9600 bps.
B5. Reset command.  

A smart card reader must support the asynchronous protocols T=0 and T=1 as described in ISO/IEC 7816-3, either in hardware or in the driver. Both protocols must be supported fully. The smart card reader and the driver must support cards that can handle both protocols.

The following protocol rules apply for the T=1 protocol:

A transmission is defined as sending a command to a smart card using one or more T=1 blocks and receiving the corresponding answer using one or more T=1 blocks as defined in ISO/IEC 7816-3.

For cards that support Information Field Size integrated circuit Card (IFSC) requests, the first transmission—after a reset of the smart card—must start with an Information Field Size Device (IFSD) request, as defined in ISO/IEC 7816-3, Amendment 1, Section

For cards that do not support an IFSD request (that is, the card replies with an R-Block indicating “Other error”), the transmission must continue with an I-Block.

After a successful RESYNCH request, the transmission must restart from the beginning with the first block with which the transmission originally started.

Support for protocols other than T=0 and T=1 is not required.

B5.6.4.5 Input device implementing a PIN data-entry keyboard complies with ISO 13491-1

An input device that uses a keyboard for personal identification number (PIN) entry must comply with ISO 13491-1:1998 Banking—Secure cryptographic devices (retail)—Part 1: Concepts, requirements and evaluation methods.

B5.6.4.6 See B1.4.12; A1.1.4.13

B5.6.5 Smart Card – FAQs

B5.6.5.1 Current smart card FAQs

See http://www.microsoft.com/winlogo/hardware/

B5.6.5.2 Updated at B5.6.4.4

B5.6.R Smart Card - Future Requirements

Announcement of additional future requirements will be published at http://www.microsoft.com/winlogo/hardware/

B6.0 Modems

© 1999-2002 Microsoft Corporation. All rights reserved.

Document info
Document views691
Page views691
Page last viewedMon Jan 23 23:39:23 UTC 2017