X hits on this document

22 views

0 shares

0 downloads

0 comments

3 / 4

5

Load Paper and Calibrate (5000 Series Only)

Start

Start

5100/5300

a) Insert 4x6 photo paper glossy side down and push the photo tray in until it clicks into place. The photo tray light should illuminate when the tray is properly inserted.

b) Once the ON/OFF indicator is a steady Green, press Start and allow the printer to print a calibration sheet.

c) Remove the calibration sheet from the output tray. Place it face down and align to the registration marks in the proper corner of the scanner glass, as shown.

6

Load Paper and Calibrate (ESP 3 and ESP 5 Printers Only)

a) Lower the front access door and pull the paper tray all the way out.

b) Insert a stack of 5-10 sheets of 8.5x11 plain paper into the paper tray.

www.kodak.com/go/aiosupport

5500

d) Lower the scanner lid and press Start. Wait 2 to 3 minutes for the calibration sheet to print.

c) For the ESP 5 printer only: Press Start. Wait 2 to 3 minutes for the calibration sheet to print. Note: Calibration is not necessary for the ESP 3 printer.

3

Document info
Document views22
Page views22
Page last viewedTue Jan 24 01:45:41 UTC 2017
Pages4
Paragraphs69
Words559

Comments