X hits on this document

PDF document

User's%20Manual%20of%20ET-STAMP-STM32.pdf - page 4 / 12

20 views

0 shares

0 downloads

0 comments

4 / 12

User’s Manual of Board Microcontroller “ET-ARM STAMP STM32 (Cortex-M3)

Structure of Board ET-ARM STAMP STM32

3

2

9

1

45

6

7

8

10

Figure Show positions of components on Board ET-ARM STAMP STM32.

  • No.1 is MCU on board.

  • No.2 is Connector USART1

download.

  • No.3 is Connector +3V Batter

  • No.4 is LED Power.

  • No.5 is LED BOOT0 (BOOT0=1).

(RS232) for

y Backup-RTC.

use

and

  • No.6 is Switch BOOT0 that can be used with Jumper J1 to choose operation mode of Board between Download from USART1 or Normal RUN. In this case, if it is ON, it is Download; on the other hand, if it is OFF, it is RUN.

  • No.7 is Jumper (BOOT1) that can be used with BOOT0 to choose operation mode of board between Download from USART1 or Normal RUN. In this case, it always is set at ISP position.

  • No.8 is Switch RESET for RESET operation of MCU.

  • No.9 is connecting point of GND.

  • No.10 is +3.3V Power Supply.

WWW.ETT.CO.TH

3

Document info
Document views20
Page views20
Page last viewedSun Oct 30 07:22:29 UTC 2016
Pages12
Paragraphs449
Words1974

Comments