X hits on this document

PDF document

User's%20Manual%20of%20ET-STAMP-STM32.pdf - page 7 / 12

26 views

0 shares

0 downloads

0 comments

7 / 12

User’s Manual of Board Microcontroller “ET-ARM STAMP STM32 (Cortex-M3)

    • 4.2

      Set Baud Rate in the range of 1200-115200; if computer has the problem or Error when using very high Baud Rate, please reduce the Baud Rate vales; in this example, it is 115200.

    • 4.3

      Set Parity Bit of Serial Port; it this case, we recommend user to choose it as None.

4.4

Set

Timeout

of

the

communication;

in

the

example, it is 1 second.

4.5

RESET MCU to run in Boot Loader as following

procedures;

  • Set Jumper BOOT1 on ISP side

= 0).

  • ON Switch BOOT0 and user can

(Signal BOOT1

see LED BOOT0

in status ON (Signal BOOT0 = 1).

  • Press Switch RESET and remove it; it makes

CPU start running in Boot Mode.

5. Click Next” to start downloading;

if everything is

OK, program will read status from CPU and report the results to user. If using STM32F103RBT6, it will display results as shown in the picture below;

6. Click Next”, Program Flash Loader starts displaying the statuses that are read from MCU to user. If using STM32F103RBT6, it will display results as shown in the picture below;

WWW.ETT.CO.TH

6

Document info
Document views26
Page views26
Page last viewedTue Dec 06 20:51:04 UTC 2016
Pages12
Paragraphs449
Words1974

Comments