X hits on this document

84 views

0 shares

0 downloads

0 comments

15 / 24

3. Cut pieces from the hook side of the included self- adhesive hook and loop material and attach them to the battery tray. Make a battery strap from the included non- adhesive hook and loop material by overlapping the material by approximately 1" [25mm]. Cut the strap to properly fit your battery and insert it through the slots in the battery tray.

4. Apply the loop side to the battery and test fit it into the fuselage.

5. Install the included prop adapter onto the motor shaft. Be sure it is pressed on as far as it will fit onto the shaft.

15

6.Install the spinner backplate, propeller, prop washer, and prop nut. Enlarge the slots in the spinner cone as necessary to fit your propeller. When satisfied, install the spinner cone to the spinner backplate using the included screws.

7. Apply the instrument panel decal to the cockpit interior.

8. If you plan to install a pilot figure, install him now before gluing the cockpit interior to the canopy hatch. We used a Williams Bros. 1/8 Sportsman pilot, stock number

Document info
Document views84
Page views84
Page last viewedTue Jan 17 12:55:53 UTC 2017
Pages24
Paragraphs425
Words10476

Comments