X hits on this document

58 views

0 shares

0 downloads

0 comments

17 / 24

GET THE MODEL READY TO FLY

Check the Control Directions

1. Turn on the transmitter and receiver and center the trims. If necessary, remove the servo arms from the servos and reposition them so they are centered. Reinstall the screws that hold on the servo arms.

2. With the transmitter and receiver still on, check all the control surfaces to see if they are centered. If necessary, adjust the pushrod positions in the screw lock connectors to center the control surfaces.

4-CHANNEL RADIO SET UP (STANDARD MODE 2)

RIGHT AILERON

RUDDER

MOVES UP

MOVES

LEFT AILERON

RIGHT

MOVES DOWN

FULL

ELEVATOR

THROTTLE

MOVES DOWN

3. Make certain that the control surfaces and the throttle respond in the correct direction as shown in the diagram. If any of the controls respond in the wrong direction, use the servo reversing in the transmitter to reverse the servos connected to those controls. Be certain the control surfaces have remained centered. Adjust if necessary.

17

Set the Control Throws

1. Use a box or something similar to prop up the bottom of the fuselage so the horizontal stabilizer and wing will be level.

Measure the high rate elevator throw first…

2. Hold a ruler vertically on your workbench against the widest part (front to back) of the trailing edge of the elevator. Note the measurement on the ruler.

MOVE THE RULER FORWARD

3. Move the elevator up with your transmitter and move the ruler forward so it will remain contacting the trailing edge. The distance the elevator moves up from center is the “up” elevator throw. Measure the down elevator throw the same way.

4.Repeat this procedure for the remaining control surfaces.

Document info
Document views58
Page views58
Page last viewedMon Dec 05 10:32:07 UTC 2016
Pages24
Paragraphs425
Words10476

Comments