X hits on this document

60 views

0 shares

0 downloads

0 comments

6 / 24

BUILDING INSTRUCTIONS

Preparations

1. If you have not done so already, remove the major parts of the kit from the box and inspect for damage. If any parts are damaged or missing, contact Product Support at the address or telephone number listed in the “Kit Inspection” section on page 5.

2. Carefully remove the tape and separate all the control surfaces. Use a covering iron with a covering sock on high heat to tighten the covering if necessary. Apply pressure over sheeted areas to thoroughly bond the covering to the wood.

Assemble the Wing Panels

1. Attach a 12" [305mm] servo extension to each aileron servo. Secure the connections using tape, heat shrink tubing (not included) or special clips designed for that purpose.

6

2. Locate the strings taped inside the aileron servo bays and tie the ends of the strings to the servo extensions. Use the string to pull the servo leads through the wing ribs.

3. Install the rubber grommets and eyelets included with the servos. Position the servos in the aileron servo bays in the orientation shown. Drill 1/16" [1.6mm] holes through the servo mounting tabs. Thread a servo mounting screw (included with the servos) into each hole and back it out. Apply a drop of thin CA to each hole to harden the wood. When the glue has dried, install the servos using the screws included with the servos.

Document info
Document views60
Page views60
Page last viewedMon Dec 05 21:01:22 UTC 2016
Pages24
Paragraphs425
Words10476

Comments