X hits on this document

54 views

0 shares

0 downloads

0 comments

8 / 24

9. Install the axles onto the landing gear legs using the included landing gear nuts and threadlocking compound.

10. Slide a 4mm wheel collar onto each axle followed by a main wheel and another 4mm wheel collar. Mark the location of the screw holes in the wheel collars onto the axles. Remove the wheel collars and wheels and use a file or rotary tool to grind flat spots onto the axles at the marks you made.

11. Install the wheel collars and main wheels onto the axles. Secure the collars onto the axles with 3mm set screws and threadlocking compound. Be sure that the wheels rotate freely. Oil them if necessary.

8

12. Thread a 2x6mm self-tapping screw into each hole in the wheel pants and back it out. Apply a drop of thin CA to each hole and allow the glue to dry. Install the wheel pants onto the landing gear with four 2x6mm self-tapping screws.

13. Bolt the landing gear legs to the wing panels using six 3x10mm machine screws and threadlocking compound.

Document info
Document views54
Page views54
Page last viewedSun Dec 04 04:05:58 UTC 2016
Pages24
Paragraphs425
Words10476

Comments