X hits on this document

199 views

0 shares

0 downloads

0 comments

65 / 96

Working in the command-line mode

Chapter 6. Working in the command-line mode

Acronis Disk Director Server supports the command-line mode for most important partition operations with diskdirectorcmd.exe utility. Using command-line mode you can:

  • Create partition

  • Delete partition

  • Resize partition.

Also you can get information on hard disk partition structure using the command /list.

6.1

Supported commands

diskdirectorcmd.exe has the following format:

diskdirectorcmd /[command] /[option1] [option2]…

The following commands are supported (each command may be accompanied by additional options):

/create_partition Creates new partition using unallocated space on the hard disk.

Supported options: /start:[start sector]

Sets the start sector for creating a partition on the hard disk unallocated space. /harddisk:X

Specifies the hard disk number where new partition will be created. /size:[partition size in sectors]

Sets the new partition size (in sectors). /filesystem:[FAT16|FAT32|NTFS|EXT2FS|EXT3FS|REISERFS]

Sets the file system for the new partition. The default value is NONE. /type:[active | primary | logical]

Sets the new partition type. By default (if this option is not defined) an active partition is created on the first hard disk and logic partitions on other disks.

/label:[partition label]

Sets the new partition label. /delete_partition

Copyright © Acronis, Inc., 2000–2010

65

Document info
Document views199
Page views199
Page last viewedSat Dec 03 21:10:04 UTC 2016
Pages96
Paragraphs2046
Words22425

Comments