X hits on this document

6 views

0 shares

0 downloads

0 comments

3 / 3

Application: Masonry/Brick Cavity Wall Insulation - Installation Guide

Mortar Droppings

1.4 After each section of leading leaf is built, excess mortar should be removed from the cavity face and mortar droppings cleaned from exposed edges of the installed board, before installation of the next run of boards. Use of a cavity board is recommended to protect board edges and make cleaning easier. Also a cavity batten will protect the installed boards and help to keep the cavity clean as the following leaf is built (figure 3 and 4)

 

 

Cut Pieces

1.5 Boards can be cut using a sharp knife or fine tooth saw to fit around windows, doors, airbricks etc. It is essential that cut pieces of boards completely fill the spaces for which they are intended and that no gaps are left in insulation

Document info
Document views6
Page views6
Page last viewedSat Dec 03 00:26:05 UTC 2016
Pages3
Paragraphs35
Words691

Comments