The following operations are commonly used when you play any sound sources.
Operations hereafter will be explained using the buttons on the front panel. You can also use the buttons on the remote control for the same functions if they have the same and similar names/marks.
Daily Operational Procedure
Selecting the Source to Play
When you have connected digital source components using the digital terminals, first change the input mode for these components to the digital input mode (see page 11).
1 Turn on the power.
See “Turning On the Power” below.
2 Select the source.
See “Selecting the Source to Play” to the right.
3 Adjust the volume.
See “Adjusting the Volume” on page 10.
4 Select the Surround or DSP modes.
See “Activating the Surround Modes” (page 25) and
“Activating the DSP Modes” (page 27).
Turning On the Power
Press one of the source selection buttons.
Selected source name appears.
On the front panel
On the remote control
Press STANDBY/ON the remote control).
The STANDBY lamp goes off. Current source name appears.
When connecting a CD recorder to the TAPE/CDR jacks, change the source name shown on the display. For details, see page 12.
By pressing the one of the audio source selection buttons—TAPE/ CDR, CD, and FM/AM—on the remote control, you can turn on the receiver and select the audio source.
Current volume level appears.
To turn off the power (into standby mode),
press STANDBY/ON remote control) again.
AUDIO on the
The STANDBY lamp lights up.
A small amount of power is consumed in standby mode. To turn off the power completely, unplug the AC power cord.