X hits on this document

133 views

0 shares

0 downloads

0 comments

16 / 40

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning in to Stations Manually

Remote NOT

Using Preset Tuning

AUTO MUTING VOLUME

To store the preset stations

Remote NOT

Before you start, remember... There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

TUNED STEREO AUTO MUTING VOLUME

1 Tune in the station you want to preset (see

1 Press FM or AM to select the band.

Once a station is assigned to a channel number, the station can be quickly tuned in. You can preset up to 30 FM and 15 AM stations.

The last received station of the selected band is tuned in.

2 Press FM/AM TUNING 5 or repeatedly until you find the frequency you want.

  • Pressing FM/AM TUNING 5 increases the frequency.

  • Pressing FM/AM TUNING decreases the frequency.

TUNED STEREO AUTO MUTING VOLUME

“Tuning in to Stations Manually”).

  • If you want to store the FM reception mode for this station, select the FM reception mode you want. See “Selecting the FM Reception Mode” on page 15.

2 Press MEMORY.

TUNED STEREO AUTO MUTING VOLUME

The channel number position starts flashing on the display for about 5 seconds.

Notes:

  • To select the band from the remote control, press FM/AM repeatedly. Each time you press the button, the band alternates between FM and AM.

  • When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.

  • When an FM stereo program is received, the STEREO indicator also lights up (except when selecting “MODE MONO” as the FM reception mode).

  • When you hold and then release the button in step 2, the frequency keeps changing until a station is tuned in.

3 Press FM/AM PRESET 5 or to select a channel number while the channel number position is flashing.

TUNED STEREO AUTO MUTING VOLUME

4 Press MEMORY again while the selected channel

number is flashing on the display. The selected channel number stops flashing. The station is assigned to the selected channel number.

5 Repeat steps 1 to 4 until you store all the stations you want.

To erase a stored preset station Storing a new station on a used number erases the previously stored one.

14

Document info
Document views133
Page views128
Page last viewedFri Dec 09 08:14:51 UTC 2016
Pages40
Paragraphs2251
Words16130

Comments