To tune in a preset station On the front panel:
1 Press FM or AM to select the band.
2 Press FM/AM PRESET 5 or ∞ until you find the channel you want.
Pressing FM/AM PRESET 5 increases the number.
Pressing FM/AM PRESET ∞ decreases the number.
On the remote control:
1 Press FM/AM to select the band (FM or AM). The last received station of the selected band is tuned in.
Each time you press the button, the band alternates between
FM and AM.
2 Press the number buttons to select a preset channel number.
For channel number 5, press 5.
For channel number 15, press +10 then 5.
For channel number 20, press +10 then 10.
For channel number 30, press +10, +10, then 10.
When you use the number buttons on the remote control, be sure that they are activated for the tune , not for the CD and others. (See page 29.)
Selecting the FM Reception Mode
When an FM stereo broadcast is hard to receive or noisy, you can change the FM reception mode while receiving an FM broadcast.
You can store the FM reception mode for each preset station (see
While listening to an FM station, press FM MODE.
Each time you press the button, the FM reception mode alternates
between “AUTO MUTING” and “MODE MONO.”
TUNED STEREO AUTO MUTING
AUTO MUTING: Normally select this. When a program is broadcasted in stereo, you will hear stereo sound; when in monaural, you will hear monaural sounds. This mode is also useful to suppress static noise between stations. The AUTO MUTING indicator lights up on the display. (Initial setting)
Select this to improve the reception (but stereo effect will be lost). In this mode, you will hear noise while tuning in to the stations. The AUTO MUTING indicator goes off from the display. (The STEREO indicator also goes off.)
After you operate any source other than the tuner using the remote control, the FM MODE button on the remote control does not work. In this case, press FM/AM on the remote control, then press FM MODE.