X hits on this document

119 views

0 shares

0 downloads

0 comments

6 / 40

Getting Started

Do not connect the AC power cord until all other connections have been made.

This section explains how to connect audio/video components and speakers to the receive , and how to connect the power supply.

Before Installation

General Precautions

  • Be sure your hands are dry.

  • Turn the power off to all components.

  • Read the manuals supplied with the components you are going to

connect.

Locations

  • Install the receiver in a location that is level and protected from moisture and dust.

  • The temperature around the receiver must be between –5˚C and 35˚C (23˚F and 95˚F).

  • Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.

Handling the receiver

  • Do not insert any metal object into the receiver.

  • Do not disassemble the receiver or remove screws, covers, or

cabinet.

  • Do not expose the receiver to rain or moisture.

Notes:

  • Supplied batteries are for the initial setup. Replace for continued use.

  • After replacing the batteries, set the manufacturers’ codes again (see pages 31 and 32).

CAUTION: Follow these precautions to avoid leaking or cracking cells:

  • Place batteries in the remote control so they match the polarity: (+) to (+) and () to ().

  • Use the correct type of batteries. Batteries that look similar may differ in voltage.

  • Always replace both batteries at the same time.

  • Do not expose batteries to heat or flame. Connecting the FM and AM Antennas

FM antenna connections

AM EXT

ANTENNA

AM LOOP

AM EXT

ANTENNA

AM LOOP

AM EXT

AM LOOP

FM Antenna (supplied)

ANTENNA

Outdoor FM Antenna Cable (not supplied)

Checking the Supplied Accessories

Check to be sure you have all of the following items, which are supplied with the receiver. The number in the parentheses indicates quantity of the pieces supplied.

  • Remote Control (1)

  • Batteries (2)

  • AM Loop Antenna (1)

  • FM Antenna (1)

If anything is missing, contact your dealer immediately.

A

Extend the supplied FM antenna horizontally.

B

Putting Batteries in the Remote Control

Before using the remote control, insert the two supplied batteries first.

1

3

2

R6(SUM-3)/ AA(15F)

Connect the supplied FM antenna as temporary measure to the FM 75 COAXIAL terminal—A

1 Press and slide the battery cover on the back of the remote control.

2 Insert the batteries.

  • Make sure to match the polarity: (+) to (+) and (–) to (–).

3 Replace the cover.

If the remote control cannot transmit signals or operate the receiver correctly, replace the batteries. Use two R6(SUM-3)/AA(15F) type dry-cell batteries.

4

If reception is poor, connect the outdoor FM antenna (not supplied)—B 1 Disconnect the supplied FM antenna. 2 Connect a 75 coaxial cable (with the standard type connector).

Document info
Document views119
Page views114
Page last viewedMon Dec 05 22:43:45 UTC 2016
Pages40
Paragraphs2251
Words16130

Comments