X hits on this document

139 views

0 shares

0 downloads

0 comments

7 / 40

AM antenna connections

AM Loop Antenna (supplied)

AM EXT

AM LOOP

ANTENNA

Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.

1

2

Outdoor single vinyl-covered wire (not supplied)

Turn the loop until you have the best reception.

Notes:

  • If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as illustrated.

  • Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

  • If reception is poo , connect an outdoor single vinyl-covered wire (not supplied) to the AM EXT terminal. (Keep the AM loop antenna connected.)

Do not connect the AC power cord until all other connections have been made.

Connecting the Speakers and Subwoofer

You can connect five speakers (a pair of front speakers, a center speaker, and a pair of surround speakers) and a subwoofer.

CAUTIONS:

  • Use only the speakers of the SPEAKER IMPEDANCE indicated by the speaker terminals.

  • Do not connect more than one speaker to each speaker terminal.

Connecting the speakers 12

3

4

+

+

+

1 Twist and remove the insulation at the end of

each speaker cord. 2 Press and hold the clamp of the speaker terminal. 3 Insert the speaker cord. 4 Release the finger from the clamp.

For each speaker (except for a subwoofer), connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

CENTER SPEAKER

FRONT SURROUND

SPEAKERS SPEAKERS

RIGHT LEFT RIGHT LEFT

+

+

To left front speaker

E

CAUTION:

To center speaker To right front speaker

To left surround speaker

To right surround speaker

5

Document info
Document views139
Page views134
Page last viewedSat Dec 10 21:30:38 UTC 2016
Pages40
Paragraphs2251
Words16130

Comments