X hits on this document

126 views

0 shares

0 downloads

0 comments

8 / 40

Getting Started

Connecting the subwoofer

You can enhance the bass by connecting a subwoofer. Connect the input jack of a powered subwoofer to the rear panel, using a cable with RCA pin plugs (not supplied).

SUBWOOFER OUT

Powered subwoofer

Placing speakers Front speakers (L/R) and center speaker (C)

  • Place these speakers at the same height from the floor, at or near

ear level.

  • Array across the front of the viewing area.

Surround speakers (LS/RS)

  • Place these speakers alongside and slightly to the rear of (but not behind) the listening position; well above ear level (60 cm (2 ft) to 90 cm (3 ft) higher).

  • Point these speakers directly across the listening area, but not at the listener’s ears.

Subwoofer (S.WFR)

  • You can place it wherever you like since bass sound is non-

directional. Normally place it in front of you.

L

R

C

45 – 60

S.WFR

LS

RS

After connecting the speakers, set the speaker installation information properly. You can use Quick Speaker Setup for it (see page 16).

6

Do not connect the AC power cord until all other connections have been made.

Connecting Audio/Video Components

When connecting individual components, refer also to the manuals supplied with them.

Analog Connections Audio component connections Use the cables with RCA pin plugs (not supplied).

  • Connect the white plug to the audio left jack, and the red plug to

the audio right jack.

If your audio components have a COMPU LINK jack See also page 28 for detailed information about the connection and the COMPU LINK remote control system.

CAUTION:

If you connect a sound-enhancing device such as a graphic equalizer between the source components and this receiver, the sound output through this receiver may be distorted.

CD player

R

CD

L

IN

CD player

To audio output

Cassette deck/CD recorder

Cassette deck or CD recorder

To audio input

To audio output

L

R

OUT (REC)

TAPE /CDR

L

IN (PLAY)

R

Note:

When connecting a CD recorder to the TAPE/CDR jacks, change the source name to CDR,which will be shown on the display when it is selected as the source. See page 12 for details.

Document info
Document views126
Page views121
Page last viewedWed Dec 07 18:59:12 UTC 2016
Pages40
Paragraphs2251
Words16130

Comments