X hits on this document

75 views

0 shares

0 downloads

0 comments

18 / 32

4-1.

Controls

Spool Gun

3

MIG Gun

4

OM-230 261 Page 14

SECTION 4 OPERATION

  • Spool Gun/MIG Gun switch on Handler 210 must be in Spool Gun position for spool gun to operate.

1

Shielding Gas Cylinder

2

1

For shielding gas connections, see welding power source Owner’s Manual.

2 Valve

Open valve on cylinder just before welding.

Close valve on cylinder when finished welding.

3

Spool Gun/MIG Gun Switch

Switch must be set in Spool Gun position for spool gun to operate.

4 Trigger

Press trigger to energize welding power source contactor, start shielding gas flow, and begin wire feed.

5

Wire Feed Speed Control

Wire feed speed is controlled by welding power source Wire Speed control (see welding power source Owner’s Manual or door chart for appropriate setting).

6

Voltage Control

Arc voltage is controlled by welding power source Voltage control (see welding power source Owner’s

Manual or door appropriate setting).

chart

for

6

5

  • To purge shielding gas line, set gun selection switch (item 3) to the MIG Gun position.Press spool gun trigger to energize gas valve. Shielding gas will flo , but spool gun will not feed wire. Hold trigger in for several seconds to purge gas line. Return gun selection switch to the Spool Gun position before welding.

sb5.1* 6/92 S-0621-C / Ref. 804 695-A / 804 696-A

Document info
Document views75
Page views75
Page last viewedSun Dec 04 20:29:12 UTC 2016
Pages32
Paragraphs1293
Words16174

Comments